Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
docs:ct-dspim [2019/02/28 18:23]
Melissa Glidewell adding Post Mount and SPIM head sections WIP 		docs:ct-dspim [2019/02/28 18:53] (current)
Melissa Glidewell [SPIM Head] adding Post Mounts section
Line 26: Line 26:
 Mount the stilts to the breadboard, align them if necessary, and mount the XY stage to the stilts. ASI has a detailed [[http://www.asiimaging.com/docs/ftp_setup|FTP setup guide]] on their documentation site. Mount the stilts to the breadboard, align them if necessary, and mount the XY stage to the stilts. ASI has a detailed [[http://www.asiimaging.com/docs/ftp_setup|FTP setup guide]] on their documentation site.
  
-===== SPIM Head ===== +===== Post Mounts ===== 
-**Tools**: 6 hex driver + 
-from ct-spim document in Google Drive +ASI has a detailed [[http://asiimaging.com/docs/post_mount_setup|Post Mount Setup guide]] on their documentation site.
-Post Mount Rods+
 Mount the post mount rods, ~55 cm center to center, to the optic table with four M6 x 25 mm bolts. Mount the post mount rods, ~55 cm center to center, to the optic table with four M6 x 25 mm bolts.
 The retaining collars are already installed on your posts at the same height; they can be adjusted later.   The retaining collars are already installed on your posts at the same height; they can be adjusted later.  
Line 36: Line 35:
 Tighten the clamp so that the split rings are symmetrical: up ~45°, towards the center, and almost exactly 20 cm center to center (the distance between CUBE-IIIs, center to center).  Tighten the clamp so that the split rings are symmetrical: up ~45°, towards the center, and almost exactly 20 cm center to center (the distance between CUBE-IIIs, center to center). 
 Leave the connection around the vertical post loose. Leave the connection around the vertical post loose.
 +
 +===== SPIM Head =====
 +**Tools**: 6 hex driver
 +from ct-spim document in Google Drive
 +Post Mount Rods
 +
 SPIM Head SPIM Head
 Attach the camera and scanner tube lenses using a 1.5 mm hex driver, see Figure 3. Attach the camera and scanner tube lenses using a 1.5 mm hex driver, see Figure 3.

Trace: